Input Voltage 24 VDC nominal. Operating range is 18 to 32 VDC
Power Consumption 4.0 watts nominal @ 24 VDC
7.5 watts maximum @ 24 VDC
10 watts maximum @ 32 VDC.
Short Circuit Current Isc: 5.4 amperes.
Isc (fuse): 3.1 amperes.
Warmup Time Two minutes from cold power-up to normal mode;
1 hour minimum recommended.
Current Output Linear 4 to 20 mA (current source/sink, isolated/nonisolated)
rated at 600 ohms maximum loop
resistance @ 24 VDC operating voltage.
Detection Range 0 to 100% LEL standard.
Other ranges are configurable.
Detectable Gases Most flammable hydrocarbon vapors are detectable.
Standard gases include methane, ethane, ethylene,
propane, butane and propylene. Detection of nonstandard
gases is configurable using the HC275
Calibration All units are methane-calibrated at the factory.
Device configuration is required for detection of
vapors other than methane.
Device Configuration Configuration parameters include tag number,
measurement range, signal processing algorithm,
alarm levels, and other selectable parameters.
Response Time T50 T60 T90
(With Baffle Installed) Without Hydrophobic Filter: 3 4 6
With Hydrophobic Filter: 6 7 12
Temperature Range Operating: –40°C to +75°C (–40°F to +167°F).
Storage: –55°C to +85°C (–67°F to +185°F).
Humidity 0 to 99% R.H. (Det-Tronics verified).
(non-condensing) 5 to 95% R.H. (FM/CSA/CENELEC verified).
Alarm Setpoint Range Low Alarm: 5 to 60% LEL
High Alarm: 5 to 60% LEL.
Accuracy ±3% from 0 to 50% LEL, ±5% from 51 to 100% LEL.
Self-Diagnostic Test All critical tests performed once per second.
Ingress Protection IP67 (CENELEC Verified).
Dust Environment II 2 D T125°C IP67
Detector Housing Material CF8M stainless steel.
Conduit Entry Options Two entries, 3/4 inch NPT or 25 mm.
FM & CSA: Class I, Div. 1, Groups C & D (T4)，Class I, Div. 2, Groups A, B, C & D (T4).
CENELEC: EEx d e [ib] IIC T6
TüV,( SIL2) CCCF